Textile Fire Shutter

FIRE RESISTANCE:  EW 15 DP1 OR EW 120 DP1  EI 120 DP1

More photos in our photogallery

ADVANTAGES: 

1. Small dimensions of the shutter guard for size of protected opening to 6 x 6m and 8 x 3 metres
2. Possibility to protect an opening up to 30 x 6 m by means of a structure with textile cover
3. Low weight stressing the building construction
4. The DP1 classification enables use for all cases when fire stops are needed

Textile fire shutter are used to part two neighbour fire sections in case of fire. For their minimum demands, they are mostly used in underground garages, in shopping centres in combinations with safety grids, and also in industrial buildings and halls, etc.

This fire shutter is advantageous for minimum spatial requirements, since under normal conditions it is coiled in a cover that is placed in such a manner not to obstruct normal operation (usually above the lower ceiling, etc.). The shutter thus does not require any larger area on the sides of the opening, as e.g. in sliding doors and gates.

The main quality required is the fire resistance of these shutters. Fire shutter ATRPU is made in two variants, which differ in the textile used.

1. With the aluminium layer textile, fire shutter ATRPU has fire resistance EW 90 (up to the area of 25 m2, or 4 m height, and unlimited length EW 120 DP1). In order to increase fire resistance, spraying (cooling with water) can be utilized. By this, fire resistance up to EI 120 DP1 can be achieved.
2. With a textile free of aluminium layer the ATRPU shutter has fire resistance EW 15 DP1. In order to increase fire resistance spraying (cooling with water) can be utilized. By this fire resistance up to EW 90 DP1 or EI 90 DP1 can be achieved.

The fire shutter ATRPU was successfully tested in the PAVUS a.s. test institute, and also in the FIRES s.r.o. test room, and is certified on the Czech and Slovak market.


The manufacturer issues Declaration of Conformity for individual commissions, within the interpretation of Act No. 22/1997 Coll., as amended, in Slovakia then pursuant to its Slovakian alternative.

Technical properties 

• The shutter is made of a special fire resistant textile the warp of which is stainless steel wires filled with glass fibres provided with surface coating made of inorganic materials (approx. thickness 0.5 mm) or of special fire-resistant textile, the warp of which is stainless steel wires filled with glass fibres provided with one-sided surface coating and one-sided aluminium foil coating.
• The shutter is designed to be placed on an opening or into it (or combination of both variants, as the case may be, fixation to concrete, masonry or steel profiles with required fire resistance.
• Standard dimension of winding shutter box is 205 x 210 mm (w x h) for dimension 6 x 6 m, for dimensions to 30 x 6 m the size of the box is 205 x 405 mm (w x h).
• The shutter is controlled electrically by means of a tube drive (electric motor with gearbox) with gravitation start-up in case power supply is interrupted.
• It allows automatic closing from the EPS switchboard (potential-free contact), even in case the supply voltage by means of a back-up source or gravitation drops out.
• Electronic control of individual functions of the shutter proceeds by means of a special AOP control unit (AVAPS, CONTROL PANEL), including control elements (buttons or key control).
• Local autonomous fire sensors, optical and acoustic signalling can be supplied together with the shutter.
• Textile shutters have a very low weight (textile = 25kg/1 m of width).
• The speed of the shutter closing is approx. 100 mm/s.
• All visible steel parts are painted in a shade according to the RAL sampler, depending on the selection of the customer.